[Abossecheno]

Because I did it on 13/07 😉

[Abossecheno]

I must tell that whilw the program was compiling I can see very much warning message, but finally get de wiimc.dol and .elf, now I’m going to try this boot.dol and will tell you what happend.
Basically the step was:
WIIMC+v9 Quik Install Guide
but the exit was:
Code: Select all
c:/wiimcp/source/fileop.cpp: In function ‘bool MountPartitions(int, int)’:
c:/wiimcp/source/fileop.cpp:869:24: warning: variable ‘disc’ set but not used [-Wunused-but-set-variable]
c:/wiimcp/source/fileop.cpp: In function ‘int VerifyPlaylistEntry(char*)’:
c:/wiimcp/source/fileop.cpp:3482:27: error: ‘diropen’ was not declared in this scope
c:/wiimcp/source/fileop.cpp:3487:16: error: ‘dirclose’ was not declared in this scope
make[1]: *** [fileop.o] Error 1
make: *** [build] Error 2

exactly the same that get Telman, so I went back and reading again the guide I look that in the STEP 4 I was forgotten the instructions were says CODE SELECT, and reply this and after continuos with the guide and the compilation was made, with the mentioned warnings messages, but without errors at the end.
I have WIN 7 Ultimate, Phenom xII 555@B55, 4 GB DDR3 mem skill 1600 and the instalation is almost clean.
The compile proccess take a long time (about 30 minutes).

[Abossecheno]

Agregate to the previous message :

Is important to say that the devkitpro that I use is the version 24 ¡¡

[Abossecheno]

First at all I want to tell that I’m from Argentina and my english isn’t good and want to say very much thanks to jhb50 and all of you that colaborates at this forum, I was receiving the files for each release of WIIMC+ in my e-mail account and finally decide to compile these, is important aclare that I haven’t any experience in programming or compiling, but however after a few failures I finally get compiling with the Expanded Windows Compile Guide.

Now especially for Telman, I was obtaining the same issue that you at the end of the first compiles, and after look wath happend with you I can finally compile the files, following the step in the STEP 4 (were says CODE:SELECT ALL) step by step, and after that the compile results in the wiimc.dol and wiimc.elf, like was (with accuracy) mencioned in the Expanded Windows Compile Guide by jhb50, I must comment that for a moment I don’t trust in this, but the truth is the reality 😉 and all of us may pay attention to the guide step by step ¡¡

Again, thanks, thanks and very much thanks to jhb50 and all of you ¡¡
Soon I’ll tell you how is the WIIMC+ functioning in my WII.

[Abossecheno]

WIIMC plays .flac very well ¡¡

[Author]

Posts